Important Note:
Please note that aftermarket remote controls are not universally compatible. They are designed for specific aftermarket systems.
If you're here without checking your existing remote's FCC ID/Part Number or your system model under the dash, please contact us at:
Descripción
Extended warranty is available on the checkout page.
This remote comes with easy programming instructions to make the system in your car accept this remote. Battery included. The number on the circuit board is ATNE. The FCC ID on the back of the remote is ELVATNE. The part number is 145SPR. This remote has been tested to ensure it sends proper signals. We have free tech support to help you complete the programming. This remote is classified as an Audiovox Type 19 Transmitter. This means it can be used to replace or be replaced by other Type 19's like 145SP, 5BCR14SP, 175SPR, 5BCR14RE, 5BCR17SPR. This remote was made for these Pursuit Systems: PR5B, PRO9276E, PRO9776E.
Programming Procedure:
1. Enter the vehicle and turn the ignition key to the "on" position.
2. Press valet button 3 times.
3. If installed, the dash LED will flash one time, and the siren will "chirp" one time, indicating the
system is ready to accept programming for channel 1.
4. Press button #1 on the keychain transmitter for 1-3 seconds until the siren emits a long "chirp" to
confirm that programming of channel I was successful. If your remote has one button, then skip to last step.
5. Press valet button 1 time.
6. If installed, the dash LED will flash twice, and the siren will "chirp" twice, indicating the system is ready to accept programming for channel 2.
7. Press button #2 on the keychain transmitter for 1-3 seconds until the siren emits a long "chirp" to
confirm that programming of channel I was successful. If your remote has two buttons, then skip to last step.
8. Press valet button 1 time.
9. If installed, the dash LED will flash thrice, and the siren will "chirp" thrice, indicating the system is ready to accept programming for channel 3.
10. Press button #3 on the keychain transmitter for 1-3 seconds until the siren emits a long "chirp" to confirm that programming of channel I was successful. If your remote has three buttons, then
skip to last step.
11. If installed, the dash LED will flash four times, and the siren will "chirp" four times, indicating the
system is ready to accept programming for channel 4.
12. Press button #4 on the keychain transmitter for 1-3 seconds until the siren emits a long "chirp" to confirm that programming of channel I was successful. If your remote has three buttons, then
skip to last step.
13. If the remote has 5 or more buttons, then continue the sequence described above programming the remaining buttons to the remaining channels.
14. To exit program mode, either turn the ignition key to the off position, or move the valet switch on then off one additional time. This is indicated by a long "chirp" from the siren.