Important Note:
Please note that aftermarket remote controls are not universally compatible. They are designed for specific aftermarket systems.
If you're here without checking your existing remote's FCC ID/Part Number or your system model under the dash, please contact us at:
Descripción
This Astrostart remote control for cars is guaranteed to work with your system if you have one of these systems installed in your car: RSS-2514XR, RSS-2504A, RSS-2524, 392-127-316 rev-0 BBF, 392-127-317 rev-1 BBW ,392-127-319 rev-1 XRT, 392-127-302 rev-1 HG, XRT, BBK, BBF, BBU, and BBW. Free technical support is available via phone and email to help you perform programming if you have difficulty.
This remote has an FCC ID of J5F-TX60A. It has a green LED light that lights up when you press the buttons. This remote features a Lock, Unlock, Remote Start and Trunk/Panic button. This remote sends it's codes on 373 MHz. The remote is tested on a Keyless Entry Tester before shipping to ensure it is sending the correct codes, proper signal strength, and battery strength.
Programming Procedure:
Four different remote controls can be programmed for a given vehicle. If a 5th remote is added the 1st is deleted. When the first code learned command is sent, all the old codes are cleared. Therefore, if you want to add a new remote, all the old ones must be programmed as well.
1. Open the hood.
2. Place the key in the ignition and turn to the RUN position.
3. Apply the brake once.
4. You now have 10 seconds to turn the key from RUN to STOP position 3 times.
5. If this sequence is correctly carried out, the control module flashes parking lights.
6. Press any button on the new remote control (except the panic button). When the access code of the new remote is memorized, the control module will respond with 1 flash of the parking lights.
7. Repeat the above procedures for each remote control that has to be programmed, up to four remotes.
8. Apply the brake.
9. New remotes are ready and now added to the system.