Descripción
Remote For Ford:
This remote features 3 buttons: Lock, Unlock, and Trunk. This remote sends it's signals on a frequency of 434Mhz. This remote will work for your vehicle if your vehicle is equipped with factory keyless entry. Brand new battery included.
FCC ID: M3N-A2C93142101
Strattec Part Number: 5929507
Ford Part Number: 164-R8151
Programming Procedure:
You must have two previously programmed coded keys and the new unprogrammed key readily accessible. See an automotive locksmith to have the spare key programmed if two previously programmed coded keys are not available.
1. Remove the key blade from the transmitter.
2. Remove the rubber covering (A) from the cup holder. With the buttons facing upward and the unlock button facing the front of your vehicle, place the first intelligent access key into the backup slot (B).
3. Press the push button ignition switch.
4. Wait five seconds and then press the push button ignition switch again.
5. Remove the intelligent access key.
6. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.
7. Wait five seconds and then press the push button ignition switch again.
8. Remove the intelligent access key.
9. Wait five seconds, then place the unprogrammed intelligent access key in the backup slot and press the push button ignition switch.
Programming is now complete. Check that the remote-control functions operate, and your vehicle starts with the new intelligent access key. If programming was unsuccessful, wait 10 seconds and repeat steps 1 through 7.
If the key has been successfully programmed it will start your vehicle and operate the remote entry system (if the new key is an integrated keyhead transmitter).
The following vehicles can use this remote when equipped with the factory keyless entry system:
Ford Edge (2017-2020) and Explorer (2018-2020)