Specifications
Part Numbers: 35113-SZN-A00
FCC ID: MLBHLIK-1T
Buttons: Lock, Unlock, Hatch, and Panic
Frequency: 314 MHz
Remote Programming:
Transponder Programming:
Chip ID: PHILIPS ID 46
Led:
Description
Extended warranty is available on the checkout page.
FCC ID: MLBHIK-1T
Acura Part Number: 35113-SZN-A00
Brand: Acura
Condition: OEM New
This remote features 4 buttons: Lock, Unlock, Panic, Hatch. This remote sends it's signals on a frequency of 314Mhz. This remote will work for your vehicle if your vehicle is equipped with factory smart keyless entry.
Programming Procedure:
Since your vehicle is not onboard programmable or you need key cutting, you will need a dealer or automotive locksmith to program the vehicle to accept the replacement remote or key or to cut a key. Please use an automotive locksmith rather than the dealer. You are likely to get a better service for a more reasonable price.
Locksmiths make their prices based on their local market as well as the cost of the equipment used for you cutting or programming. Locksmith equipment for key cutting and vehicle programming is very expensive and most of the charge is to compensate them for their initial equipment investment.
An automotive locksmith will program your new remotes or keys by hooking up an expensive scan tool to your vehicle computer and making the vehicle learn the new remotes or keys.
The following vehicles can use this remote when equipped with the factory keyless entry system:
Acura ZDX (2010-2012)
Programming Procedure #510 & 99
Keyless Entry Remote Programming:
IMPORTANT: Entering the programming mode cancels all learned remote codes, so no previously programmed remotes will work. You must program all remotes, including existing ones now. Separate your ignition key from remotes on keychain.
- Start with your key in your right hand and any remote in your left hand. Keep all additional remotes easily accessible to your left hand. Insert the key into the ignition.
- Perform these steps within 5 seconds.
- Turn the ignition to the ON position (where the instrument panel lights are turned on without starting the engine.)
- Press the UNLOCK button on the remote and release.
- Turn the ignition back to LOCK (the position where the key is inserted) and leave the key in the ignition.
- Turn the ignition to the ON position (where the instrument panel lights are turned on without starting the engine.)
- Press the UNLOCK button on the remote and release.
- Turn the ignition back to LOCK (the position where the key is inserted) and leave the key in the ignition.
- Turn the ignition to the ON position (where the instrument panel lights are turned on without starting the engine.)
- Press the UNLOCK button on the remote and release.
- Turn the ignition back to LOCK (the position where the key is inserted) and leave the key in the ignition.
- Within 5 seconds turn the ignition to ON.
- Press the UNLOCK button on the same remote and release. The power door locks will cycle to confirm the system is in programming mode.
- Within 10 seconds press the UNLOCK button on the same remote again and release. The door locks will cycle to confirm that the system accepted this remote.
- Repeat step 5 for second or third remotes.
- Turn the key back to LOCK and remove from ignition to exit programming mode.
Transponder Key Programming:
Use the websites below or your local yellow pages to locate a local automotive locksmith.
www.autolocksmithfinder.com
An automotive locksmith will cut the key and program your vehicle to start with new keys by hooking up an expensive scan tool to your vehicle, making the vehicle learn the new transponder chip.
Compatibility