2006 Toyota Matrix Remote PN: 89742-02010

SKU: 4221A-OEM

Condition: OEM New
Price:
Sale price$109.95

Shipping calculated at checkout

Stock:
Only 3 units left

Description

Works on: 2003-2008 Toyota Matrix with factory keyless entry system. 

This remote has an FCC ID of GQ43VT14T. 

The Toyota part number is 89742-02010. 

 This remote has 3 buttons on the front (LOCK, UNLOCK, HATCH) and 1 button on the back (PANIC.)  This remote sends coded transmissions on a frequency of 315MHz.  The remote is tested before being sent to you on a keyless entry tester to ensure it is sending proper signals.

PROGRAMMING INSTRUCTIONS:

1.  Start with the following conditions:
a.  Key is out of the ignition
b.  Driver door is open (all other doors are closed)
c.  Driver door is unlocked (other doors don?? matter).

2.  Perform the next two steps within 5 seconds:
a.  Insert the key into the ignition (don?? turn it) and pull it out.
b.  Insert the key into the ignition (don?? turn it) and pull it out.

3.  Perform these steps within 40 seconds:
a.  Close then open the driver?? door.
b.  Close then open the driver?? door.
c.  Insert the key into the ignition (don?? turn it) and pull it out.

4.  Perform these steps within 40 seconds:
a.  Close then open the driver?? door.
b.  Close then open the driver?? door.
c.  Insert the key into the ignition.
d.  Close the driver?? door.
e.  Turn the ignition to ON (as far as you can go without cranking your engine) then back to OFF.
f.  Remove the key from the ignition.

5.  Within 3 seconds, the power door locks should cycle (lock then unlock) automatically indicating successful entry into programming mode. Return to Step 1 if the locks do not cycle at this point.

6.  Perform these steps within 40 seconds:
a.  Press the lock and unlock buttons on the transmitter simultaneously for 1 second.
b.  Immediately after releasing the lock and unlock buttons, press the unlock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle (lock then unlock) once indicating successful programming. If the door locks cycle twice, repeat steps 6a and 6b for this remote as it has not been accepted.

7.  Open driver?? door.