Factory Installed System:
Perform the following test to see if you have this system:
Start with the following conditions:
- Key is out of the ignition
- Driver door is open (all other doors are closed)
- Driver door is unlocked (other doors don’t matter).
- Perform the next two steps within 5 seconds:
- Insert the key into the ignition (don’t turn it) and pull it out.
- Insert the key into the ignition (don’t turn it) and pull it out.
- Perform these steps within 40 seconds:
- Close then open the driver’s door.
- Close then open the driver’s door.
- Insert the key into the ignition (don’t turn it) and pull it out.
- Perform these steps within 40 seconds:
- Close then open the driver’s door.
- Close then open the driver’s door.
- Insert the key into the ignition.
- Close the driver’s door.
- Turn the ignition to ON (as far as you can go without cranking your engine) then back to OFF.
- Remove the key from the ignition.
- Within 3 seconds, the power door locks should cycle (lock then unlock) automatically indicating your vehicle is equipped with the system.