Valet 710T Programming Instructions

The following Programming Routine is available to program any keyfob whose PC Board ID is DT8B, DT8C, or RT4A, whether or not the remote’s FCC ID is EZSDEI493C or EZSDEI467 or EZSDEI492, EZSDEI493 or something else, when being used on these systems: Automate 2, Automate 3+, Automate 5+, Equalizer 2, Valet 710T, Hornet 718T, Hornet 719T, Python 650, Python 750, Sidewinder 5000, Sidewinder 6000, Wasp 718W, Viper 300+, Viper C 50, Viper 500+, Viper 500NX. To be able to go into the Programming Routine, the system’s Valet/Programming button ought to be connected to the blue port.

Channel 1 is for Arm, Disarm, and Panic. Channel 2 is made for Silent Mode or Remote Valet mode in the event the system was set up for this. Channel 3 is optional and only used if your system was set up for a 3rd channel.
1. Open the driver door.
2. Stick key in ignition cylinder and switch towards the ON/RUN position.
3. Press the valet button ONCE, push again and hold it until step 5. The system will chirp once.
4. Press button #1 on the remote. One chirp indicates channel has been learned.
5. Let go of the valet button. Remove key to conclude.

If your system uses channel 2:
1. Open the driver's door.
2. Insert key in ignition and turn into the ON/RUN position.
3. Push the valet button TWICE, push once more and hold it until step 5. The system will chirp once.
4. Press button #2 on the remote. 1 chirp indicates channel has been learned.
5. Let go the valet button. Take out key to finish.

If your system uses channel 3:
1. Open up the driver's door.
2. Put key in ignition cylinder and switch into the ON/RUN position.
3. Push the valet button THRICE, push once more and hold it until step 5. The system will chirp once.
4. Press both buttons together on the fob . 1 chirp confirms channel has been learned.
5. Release the valet button. Remove key to conclude.