Channel 1 is made for Arm, Disarm, and Panic. Channel 2 is made for Silent Mode or Remote Valet mode when the system was wired for this. Channel 3 is optional and only used if your system was wired for a third channel.
1. Open up the driver's door.
2. Stick key in ignition cylinder and turn into the ON/RUN position.
3. Push the valet button ONCE, push once more and hold it until step 5. The system will chirp once.
4. Push button #1 on the remote. 1 chirp verifies channel has been learned.
5. Let go the valet button. Take out key to end.
If your system uses channel 2:
1. Open the driver's door.
2. Put key in ignition cylinder and turn to the ON/RUN position.
3. Push the valet button TWO TIMES, push once more and hold it until step Five. The system will chirp once.
4. Push button #2 on the remote. A single chirp verifies channel has been learned.
5. Let go of the valet button. Remove key to finish.
If your system uses channel 3:
1. Open up the driver door.
2. Stick key in ignition cylinder and switch towards the ON/RUN position.
3. Push the valet button THRICE, push again and hold it until step 5. The system will chirp once.
4. Press both buttons together on the remote fob . One chirp verifies channel has been learned.
5. Let go the valet button. Remove key to end.