Programming Procedure #850

Note: Perform steps 1-4 within 45 seconds.

1. Sit in the driver’s seat and close all doors, rear gate and trunk lid.
2. Open the driver’s door.
3. Close the door.
4. Insert keys in ignition. Turn the ignition switch from LOCK to ON (as far as you can go without cranking the engine) ten times in rapid succession (within 15 seconds), ending in LOCK. The horn chirps once to indicate that the system has entered programming mode.
5. Open the driver’s door.
6. Close the driver’s door
7. Press any button on the transmitter you wish to program top the system. The horn will chirp two times to indicate that the transmitter has been programmed.
8. Any additional transmitters can also be programmed at this time (including your old ones.) Repeat steps 5 through 7 for each additional transmitter.
9. Remove the ignition key from the ignition switch. The horn will chirp three times to indicate system is out of programming mode.