1. Begin with the key out of the ignition.
  2. Close all doors.
  3. Open driver’s side door and leave open.
  4. Perform the following within 24 seconds:
    1. Insert key in ignition.
    2. Turn key to ON (without starting engine) and OFF
    3. Repeat step b two more times.
    4. Push driver door frame button three times (black rubber button located inside door frame that tells vehicle whether door is open or closed).
  5. Buzz sound or chime confirms you have entered programming mode. If not, wait 40 seconds and return to step 4.
  6. All remotes must be programmed at this time including the old ones. Push any button on the remote two times. A chime will indicate the vehicle has accepted the new code.
    1. If there is only one remote then press any button on the same remote twice and a chime sounds. Repeat this step one last time for a total of three programmings.
    2. If there are two remotes, press any button on the second remote twice intul chime sounds. Repeat this step one more time for the second remote for a total of three programmings.
    3. If there are three remotes, press any button on the second and third transmitters twice (one after another) until a chime has sounded for each of the three transmitters.
  7. Push driver door frame button one time. Two buzz sounds or chimes should be heard to confirm successful programming. (This could happen automatically after programming third remote.)