Programming Procedure #475

To add new remotes without erasing existing remotes:

1. Open the driver’s door.
2. Insert the key into ignition.
3. Within 5 seconds, turn the ignition to ACC position and then to LOCK position three times within three seconds.
4. Within 10 seconds close and open the door two times.
5. Turn the ignition to ACC and then to LOCK three times within three seconds.
6. Within 10 seconds close then open the door. The door locks will cycle twice to confirm programming mode has been entered.
7. Within 20 seconds press the LOCK button on the remote you are programming. The door locks will cycle to confirm.
8. Within 20 seconds press the UNLOCK button on the remote. The door locks will cycle again to confirm.
9. Repeat from step 1 for each additional remote you wish to program.
10. Remove key from ignition.

To delete all remotes and add one new one:

1. Open the driver’s door.
2. Insert the key into ignition.
3. Within 5 seconds, turn the ignition to ACC position and then to LOCK position three times within three seconds.
4. Within 10 seconds close and open the door two times.
5. Turn the ignition to ACC and then to LOCK five times within five seconds.
6. Within 10 seconds close then open the door. The door locks will cycle once to confirm programming mode has been entered.
7. Within 20 seconds press the LOCK button on the remote you are programming. The door locks will cycle to confirm.
8. Within 20 seconds press the UNLOCK button on the remote. The door locks will cycle again to confirm.
9. Remove key from ignition.