1. Locate the keyless entry program line – a dark green wire with a molded plastic insulator on the end. The program line is located under the left side of the instrument panel. The wire is taped back to the harness (left of the steering column near the floor) and terminated with a black rubber mold.
  2. Connect the program line from the Remote Keyless Entry Module to ground with a suitable jumper wire.
  3. Insert key in ignition and turn to the ON position.
  4. Press any button on the remote to be programmed. If there is a second remote to be programmed then press a button on that remote. The locks will cycle each time a remote is added.
  5. Disconnect the programming line from ground, turn ignition off and remove key.