Programming Procedure #305
Note: The programming connector is taped to the wire assembly leading to the keyless entry receiver module (approximately 6 inches from the receiver,) which is located on the driver’s side of the lower instrument panel to the right of the steering column, just above the driver’s right foot. It’s a white or light gray plastic connector with two terminals that is not plugged into anything.
- Put the ignition to RUN or ACC and momentarily jump the two program connector terminals with a suitable jumper wire. The system will respond by locking and then unlocking all doors.
- Press any button on the first remote. All doors will lock and unlock to verify programming of that remote.
- Press any button on each additional remotes (including your old ones) allowing a pause for the door locks to cycle after each remote. The keyless entry system will allow up to four remotes to be programmed.
- Turn the ignition to OFF. All doors will lock then unlock.