Programming Procedure #265

  1. Start with the following conditions:
    1. Key is out of the ignition
    2. Driver door is open (all other doors are closed)
    3. Driver door is unlocked (other doors don’t matter).
  2. Perform the next two steps within 5 seconds:
    1. Insert the key into the ignition (don’t turn it) and pull it out.
    2. Insert the key into the ignition (don’t turn it) and pull it out.
  3. Perform these steps within 40 seconds:
    1. Close then open the driver’s door.
    2. Close then open the driver’s door.
    3. Insert the key into the ignition (don’t turn it) and pull it out.
  4. Perform these steps within 40 seconds:
    1. Close then open the driver’s door.
    2. Close then open the driver’s door.
    3. Close the driver’s door.
    4. Insert the key into the ignition.
    5. Turn the ignition to ON (as far as you can go without cranking your engine) then back to OFF.
    6. Remove the key from the ignition.
  5. Within 3 seconds, the power door locks should cycle (lock then unlock) automatically indicating successful entry into programming mode. Return to Step 1 if the locks do not cycle at this point.
  6. Perform these steps within 40 seconds:
    1. Press the lock and unlock buttons on the transmitter simultaneously for 1 second and release.
    2. Immediately after releasing the lock and unlock buttons, press the lock button by itself and hold it for 2 seconds. Within 3 seconds, the door locks should cycle (lock then unlock) once indicating successful programming. If the door locks cycle twice, repeat steps 6a and 6b for this remote as it has not been accepted.
    3. Within 40 seconds, repeat steps 6a and 6b for each additional transmitter.
  7. Open driver’s door.