Locate the Programming Connector in the trunk (center of rear shelf). It is a plastic connector with two wires leading up to it. The connector is not plugged into anything. You may have to pull back trim to access the connector.
The programming connector should have two terminals. Connect both terminals with a suitable jumper wire. The Keyless Entry Module will lock then unlock all the door lock motors once. Make sure the terminals remain connected throughout the programming procedure.
Press and hold the LOCK and UNLOCK buttons on the transmitter simultaneously for at least 15 seconds or until the vehicle automatically locks and unlocks the door locks. Your new remote has been accepted and all existing remote codes have been erased.
Repeat the previous step for each transmitter to be programmed. Do not remove jumper wire in between programming of transmitters.
Remove the jumper wire from the Keyless Programming Connector.
Fast shipping
Same day handling! Choose from multiple USPS and UPS shipping methods.
Satisfaction Guaranteed
30 day no hassle returns and exchanges.
Top-notch Support
Our agents can walk you through programming and troubleshooting.
Security and Privacy
We use ssl security to protect your data. We won't ever sell your data.
