1. Make sure the ignition is in the OFF position.
  2. Locate the programming connector in the drivers side trunk. It is a plastic connector with 2 wires leading to it. It is not plugged into anything. You may have to pull back the trim to access the connector.
  3. The programming connector has two terminals. Connect the terminals with a suitable jumper wire. The locks will cycle to confirm programming mode. Keep the jumper wire connected.
  4. Press the UNLOCK button on the remote once. The door locks will cycle to confirm the remote has been learned.
  5. Repeat the previous step for a second remote (if any, including the old ones).
  6. Remove jumper wire.