1. Make sure the ignition is in the OFF position.
  2. Locate the keyless entry programming connector behind the passenger side instrument panel accessed by opening the glove box and looking to the top left side where it is held in place with a clip. It is a plastic connector with 2 wires leading up to it. The connector is not plugged into anything. You will have to pull out the inner tray of the glove compartment to access the connector.
  3. The programming connector should have two terminals. Connect the terminals with a suitable jumper wire. The locks with cycle (lock and unlock by themselves) to indicate you have entered programming mode.
  4. Press the UNLOCK button on the first remote. The locks will cycle to confirm.
  5. Press UNLOCK on a second remote (if any.) The locks will cycle to confirm.
  6. Remove jumper wire.