Programming Procedure #180

  1. Insert key into ignition and turn to the ON position (as far as it goes without cranking the engine.
  2. Press OFF and WARM (temperature up) on the Climate Control Panel simultaneously. The IPC Display will light all telltales, go blank, then enter “Diagnostic Mode.”
  3. Note: On Analog IPC’s that use a dial for the temperature control, press the main OFF and PASSENGER COOLER (far right button toggle UP) buttons until “RFA?” is displayed, then press FAN UP.
  4. Press FAN DOWN to scroll through the diagnostic menu until “RFA?” is displayed, then press FAN UP.
  5. Press FAN DOWN until “RFA OVERRIDE” is displayed, then press FAN UP.
  6. “NO OVRD RF S00” is displayed, press FAN UP.
  7. “PGM Fob 1 S01” is displayed; press WARM button and a “99” will be displayed in the upper left corner of the IPC Display just below the odometer. The system is now ready to program the #1 remote (remote must have a #1 on the back to be accepted.)
  8. Press and hold the TRUNK button on the remote, and within one second of pressing it, press and hold the LOCK button. Continue to hold both buttons until the locks cycle or until the display changes from “99” to “0.” If the remote has not programmed within 30 seconds of entering “99” override display, the display will return to “0” and you must go back to step 6.
  9. To program remote #2, press FAN UP button until “RF PROGRAM FOB #2” is displayed. Press WARM button.
  10. Follow step 7 to program remote #2.
  11. Press RECIRC or RESET to exit programming.