The following Programming Procedure enables you to add any remote keyfob whose circuit board number is DT8B, DT8C, or RT4A, regardless of whether the remote’s FCC ID is EZSDEI493C or EZSDEI467 or EZSDEI492, EZSDEI493 or something different, when being used on these systems: Automate 2, Automate 3+, Automate 5+, Equalizer 2, Valet 710T, Hornet 718T, Hornet 719T, Python 650, Python 750, Sidewinder 5000, Sidewinder 6000, Wasp 718W, Viper 300+, Viper C 50, Viper 500+, Viper 500NX. In order to go into the Programming Routine, the system’s Valet/Programming button will have to be attached to the blue port.
Channel 1 is for Arm, Disarm, and Panic. Channel 2 is for Silent Mode or Remote Valet mode in the event the system was wired for it. Channel 3 is optional and only used if your system was set up for a third channel.
1. Open the driver door.
2. Stick key in ignition and turn to the ON/RUN position.
3. Push the valet button ONCE, push once more and hold it until step Five. The system will chirp once.
4. Push button #1 on the remote. One chirp indicates channel has been learned.
5. Let go the valet button. Take out key to end.
If your system uses channel 2:
1. Open up the driver's door.
2. Stick key in ignition and switch to the ON/RUN position.
3. Push the valet button TWO TIMES, push again and hold it until step 5. The system will chirp once.
4. Push button #2 on the remote. One chirp indicates channel has been learned.
5. Let go of the valet button. Remove key to finish.
If your system uses channel 3:
1. Open up the driver's door.
2. Stick key in ignition and switch into the ON/RUN position.
3. Press the valet button THREE TIMES, press once more and hold it until step 5. The system will chirp once.
4. Press both buttons together on the remote fob . One chirp indicates channel has been learned.
5. Let go the valet button. Remove key to finish.