FCC ID EZSDEI467 Programming Instructions

The subsequent Programming Method is available to add any remote keyfob whose circuit board ID is DT8B, DT8C, or RT4A, regardless of if the remote’s FCC ID is EZSDEI493C or EZSDEI467 or EZSDEI492, EZSDEI493 or something different, when used on these systems: Automate 2, Automate 3+, Automate 5+, Equalizer 2, Valet 710T, Hornet 718T, Hornet 719T, Python 650, Python 750, Sidewinder 5000, Sidewinder 6000, Wasp 718W, Viper 300+, Viper C 50, Viper 500+, Viper 500NX. In order to get into the Programming Procedure, the system’s Valet/Programming button needs to be plugged into the blue port.

Channel 1 is made for Arm, Disarm, and Panic. Channel 2 is for Silent Mode or Remote Valet mode if your system was wired for this. Channel 3 is optional and only used in case your system was set up for a third channel.
1. Open the driver's door.
2. Stick key in ignition and turn to the ON/RUN position.
3. Push the valet button ONCE, push again and hold it until step 5. The system will chirp once.
4. Push button #1 on the remote. One chirp verifies channel has been learned.
5. Let go the valet button. Take out key to conclude.

If your system uses channel 2:
1. Open up the driver door.
2. Insert key in ignition and turn towards the ON/RUN position.
3. Push the valet button TWO TIMES, press again and hold it until step Five. The system will chirp once.
4. Push button #2 on the remote. A single chirp indicates channel has been learned.
5. Let go the valet button. Remove key to end.

If your system uses channel 3:
1. Open up the driver's door.
2. Stick key in ignition cylinder and turn into the ON/RUN position.
3. Press the valet button THRICE, press again and hold it until step 5. The system will chirp once.
4. Press both buttons together on the remote transmitter . One chirp verifies channel has been learned.
5. Release the valet button. Take out key to end.