The following Programming Method may be used to program any fob whose circuit board number is DT8B, DT8C, or RT4A, regardless of if the transmitter's FCC ID is EZSDEI493C or EZSDEI467 or EZSDEI492, EZSDEI493 or something else, when used on these systems: Automate 2, Automate 3+, Automate 5+, Equalizer 2, Valet 710T, Hornet 718T, Hornet 719T, Python 650, Python 750, Sidewinder 5000, Sidewinder 6000, Wasp 718W, Viper 300+, Viper C 50, Viper 500+, Viper 500NX. So that you can get into the Programming Routine, the system’s Valet/Programming button must be plugged into the blue port.
Channel 1 is for Arm, Disarm, and Panic. Channel 2 is designed for Silent Mode or Remote Valet mode if your system was wired for this. Channel 3 is optional and only used in case your system was set up for a third channel.
1. Open the driver door.
2. Stick key in ignition and switch towards the ON/RUN position.
3. Push the valet button One time, push again and hold it until step 5. The system will chirp once.
4. Press button #1 on the remote. One chirp indicates channel has been learned.
5. Let go of the valet button. Take out key to complete.
If your system uses channel 2:
1. Open up the driver's door.
2. Insert key in ignition cylinder and switch towards the ON/RUN position.
3. Press the valet button TWICE, push once more and hold it until step Five. The system will chirp once.
4. Push button #2 on the remote. 1 chirp verifies channel has been learned.
5. Let go of the valet button. Remove key in order to complete.
If your system uses channel 3:
1. Open the driver door.
2. Stick key in ignition and switch into the ON/RUN position.
3. Press the valet button THRICE, push again and hold it until step 5. The system will chirp once.
4. Push both buttons together on the remote keyfob . 1 chirp verifies channel has been learned.
5. Let go of the valet button. Remove key to finish.